Tester II - 2nd Shift

Tester II - 2nd Shift

Eaton's IS AER FMC division is currently seeking a Tester II - 2nd Shift. The hourly rate for this position is $25.00 + $1.00 shift differential per hour. The hours for this shift are 2:00 pm - 10:30 pm. This position is also eligible for a variable incentive program.

Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What You'll Do:

The Tester is responsible for performing bench testing of a diversified line of parts, subassemblies and completed units following established procedures.

• Perform bench work requiring use of simple limit direct reading gauges and meters
• Build / fabricate own setup operations on less complicated test systems
• Connect products to be tested to test equipment, monitor gauges and meters, verify and record results
• Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner. Understand and meet all departmental safety objectives and goals.
• Keep assigned work-area clean, organized, and orderly per 5S standards.
• Perform Lean Initiatives including Continuous Improvement
• Lead and interpret blueprints & schematics

Qualifications:

Basic (Required) Qualifications:

• Must have a high school diploma or GED from an accredited institution.
• Minimum of three (3) years' work experience in Fuel, Hydraulic and/or Pneumatic Testing is required
• Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
• No relocation benefit is offered for this position. Only candidates residing within the immediate area of Irvine, CA (50 miles) will be considered for this position.
• This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.

Preferred Qualifications:

• Previous work experience in either the Aerospace, Automotive, and/or Airline Maintenance industries

Position Criteria:

• Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers
• Ability to use direct reading and fixed gauges
• Able to read blueprints and schematics
• Detailed Oriented
• Works Independently
• Continuous Improvement
• Follow Safety Practices & Procedures
• Ability to lift up to 50lbs